Causes of Accidental Damage of Equipment in Organic Fertilize Production Line

Organic fertilizer equipment in operation, inevitably will receive wear and tear. During the normal service life of the equipment, these controllable damage and wear do not have a great impact on the equipment, so it is not necessary to worry too much. But wear and tear is different, some just affect the normal work of the equipment, and even can cause danger. Therefore, manufacturers of organic fertilizer equipment wear to do a good job of inspection and management.

8 accidental wear and tear of organic fertilizer equipment and its causes solutions

1, running-in wear: this is the normal wear of organic fertilizer equipment is more common. At the beginning of friction between new friction surfaces, the wear speed is faster, and after reaching a certain degree, the actual contact area between friction surfaces becomes larger, and the unit pressure decreases accordingly, and the wear speed also decreases.

2, abrasive wear: wear surface is cut by hard grain damage wear.

3, glue welding wear: when a material on the friction surface is too light, the contact pressure is too large, the lubrication condition is too poor or the temperature is too high.

4. Fatigue wear and tear: it occurs more in the friction surface with rolling friction, and the crack surface on the friction surface of the parts leads to the metal surface falling off. The main reason is that the contact pressure of the surface material exceeds the compressive strength due to compression elastic extension and cold and hot action.

5, corrosive wear: friction surface due to water vapor, chemical gases or oxides and other media interference, so that the friction surface oxidation metamorphism. Generally for oxidation wear and chemical corrosion wear.

6. One factor that is relatively easy to cause the wear of organic fertilizer equipment is dust. Organic fertilizer equipment in operation and after the discharge are produce dust, if not in time for cleaning maintenance, dust will enter into equipment such as various joint, tired month product, more and more, the greater the equipment joint friction will, even can cause the accumulation of germs, different degrees of corrosion to the equipment, the impact on the performance of the equipment. So we require the staff in the use of organic fertilizer equipment, need to do a good job of inspection and maintenance of equipment.

7. In the process of operation of organic fertilizer, our staff also need to pay attention to the lubrication degree at the connection of equipment. The long-term use of equipment is a severe test for equipment lubrication. Once there is a jam, the friction of the equipment will increase, only high lubrication will provide good power support for the operation of organic fertilizer equipment, and the staff should develop a good habit of cleaning and maintaining equipment on time.

8. In addition, we need to pay special attention to the motor friction is also need to pay attention to, otherwise it will affect the use effect of organic fertilizer equipment, staff need to pay attention to check the operation of the motor. Especially before the load operation, the line of the motor should be checked, and if there is any damage, it should be updated immediately to ensure normal operation.

In fact, some of the above 8 accidental damages and causes can be avoided by normal maintenance in daily life. There are five elements to do daily maintenance.

1. Machines and parts that have great influence on the system and have no maintenance time.

2. Check the oil feed, abnormal sound, vibration and temperature of the machine and parts; If these machines and parts are not checked and treated every day, it may cause major accidents.

3, although the influence of the system is small, easy to produce abnormal conditions of the machine and parts.

4. Corresponding inspection for starting and closing work on the same day.

5. Routine inspection, adjustment and cleaning.